1985 Trojan 36 Tri Cabin For Sale

Nice classic Trojan 36' Tri Cabin motor yacht. Until the end of 2017, she was a Minnesota boat hanging out in fresh water and only used during the summer.

Please look at all the pictures closely, notice the complete lack of salt air corrosion. I mean, look at those engines! Look at that wiring terminal!

If you're looking for a comfortable cruiser/live-aboard down here in the southern coastal states, you won't find one in this price range that has been so protected from the elements.

The owners took her down from Minnesota to Jacksonville Florida fall of 2017, and have been updating her here since then.

Large main salon with over 6' of headroom. Fore and aft staterooms with en-suite heads make for comfortable traveling with others. Aft master bedroom, master bath with shower/tub. Fore V-berth with Jack and Jill bath with shower, accessible to main salon and bedroom.

She even comes with a dinghy and motor to save you hotel money, take the dinghy to shore for dinner and supplies, stargaze and sleep on the boat in comfort with her fore and aft air conditioning units.

Ariel is a big comfortable cruiser ready for her next owner.

Fresh bottom paint applied at the end of 2017.

Many, many other updates listed below. She's not perfect, but with a fiberglass hull, and Minnesota history, she's got great bones.

She has an access panel through the salon roof for engine/generator work if ever needed.

Check out the video!

Dinghy included: West marine with 4hp Mercury four stroke

She is a classic cruiser and has some issues like any great older cruiser does. The generator needs a little coaxing sometimes to get going but works when she starts. The engines run fine, other than one will start to sputter above 2500 RPM, the owner thinks it has something to do with the new carbs that were installed a while ago.

The windows show some signs of leakage, and the radar is quite dated, but still works.

Boat Repairs and Upgrades from the owner:

05/21/18 - engine compression test with results good
05/22/18 - disassemble carburetor and clean
05/25/18 - convert to electronic ignition
10/24/17 - install main engine strainers with mounting blocks
10/13/17 - remove and replace valves and fittings for both AC units and genset
11/06/17 - install zincs on running gear (trim tabs and rudders)
11/07/17 - install new lines, fluid, bleed air out of trim tab system
11/08/17 - new spark plugs
08/12/17 - replace starboard engine crank, coil, contact assembly and condenser.
08/30/17 - replace toilets and added new wiring
08/30/17 - new circuit breaker and solenoid kits for new toilets
08/30/17 - installed new AC raw water strainers
08/30/17 - relocated the AC pump out of the bilge
08/30/17 - installed USB ports with access wiring
08/14/17 - replaced points and condenser
08/10/17 - installed 2 Fireboy fire extinguishers in engine compartment
07/25/17 - replace nav light, running light and anchor light bulbs
07/20/17 - install three new ABC fire extinguishers
07/07/17 - replace impellers
07/07/17 - change oil and fuel filters, fuse holder
07/07/17 - replace carburetors and set the timing
07/07/17 - remove and replace shaft struts, press in new Cutlass bearings
07/07/17 - install new bilge pumps and float switches
07/07/17 - install new bronze props
07/07/17 - install new fuel sender and new ground wire
07/07/17 - replace batteries